FOR SALE;
-Mallory comp 250 fuel pump, and big 2-port
Holley reg- $225.00
-499" shortblock, Hardblock filled 400 lowdeck,
4.150 stroke billet crank, 8-bolt sfi flexplate,
MGP aluminum rods, JE flat top pistons,
All 5 ProGram billet caps, ARP mainstuds,
All new with only 12 passes, has been best of 9.38 at 142.6
with unported 440-1's in a 3200lb
a-body on leaf springs N/A.
going different route.
-8 3/4 rear out of an A-body, has been narrowed 1" per side,
back braced, fill neck on top, drain on bottom,
Moser 35 spline axles with 5/8 studs, 35 spline lightweight spool,
M/P aluminum center section, 1350 billet yoke, spring perches moved into frame,
ready to bolt in and race, or can also be bought with
Aerospace disc brake set-up. Center section only has 12 passes
on it since new.
-$1700 without brakes
-7 Venolia pistons, .055 over 440,I have
all 8 with good rings but the #6 piston
has a pc of valve spring lodged in the
bottom ring grove and broke it-
-Brooks aluminum rods, stock length 440
with stock crank journal and pin size- $200.00
-Charlies aluminum b/b oil pan and
pick up- $150.00
-Indy 440 intake for dominator carb, port
matched to -1's, also has port work done
under carb by Nick at Compu-Flow, I have
$600.00 in this intake- $400.00
-Smith Bros c/m pushrods for 440,
9.250 length, 18 passes- $140.00
-Edelbrock adj timing set for b/b- $25.00
-10" 4400 conv, was a T/A, was freshened by CCM
of Hanover, Pa -$300.00
-Indy pushrods, 9.800, 80 passes, 15pcs-
-Indy pushrods, 9.825, 14pcs-
-set of 6.570 aluminum rods with .990 pin dia for
500" low deck, 23 passes -$200.00
-small block aluminum valve covers, purple anodized,
have a couple of battle scars -$25.00
-W-2 header plates, new- $20.00
-brand new traction bars, yellow -$30.00
-pair cop car wheels with worn out m/t tires -$50.00
-2 15x8 Centerlines Auto Drags with 3 1/2" rear space
and 4 1/2" bolt circlewith BFG all/season radials, tires
are in good shape 265/50/15, 4.5" bolt pattern -$225.00
-4 big bolt ralley wheels, with centers and trim rings,
two of them have brand new 225/75/14 radials -$225.00
-69 B-body 8 3/4 rear end, cleaned and painted, with 3:23 open center,
with axles, there are no brakes or backing plates -$220.00
-shark tooth headlight bezels, nice shape -$50.00
-273 Hipo 4bbl intake, casting #2536563 $120.00
-88 318 magnum engine out of truck, has less than
500 miles on rebuild, has new fuel pump, new
high flow water pump, p/s pump, pulleys, belts,
ready for your car or truck. $650.00
-Mark Williams billet 1350 course spline rear end yoke,
brand new part# 39016-G- $175.00
-OCC Stingray bike, new, Maroon/Chrome
Have box, but it's not the org box- $150.00
-72 Demon 340 4spd project car for sale
-69 Dart Swinger 340 4spd project car for sale
-Also have hundreds of die cast collectables,
would like to sell whole lot, please email
for complete list-
contact
mopar@innernet.netfor info and pics
lots of Mopar stuff for sale
e-mail with needs
Thanks
