I need these parts gone, tired of storing them.
1. Hoosier 295/65-15 DOT drag radials. tires have 46 runs on them, never screwed to the rim. Surely some life left or use for mockup. $25.00/pr.
2. Hoosier 10.5 x 28 bias slicks, stiff sidewall, C07 compound. Tires have only 10 runs on them....still like new. Again, never screwed to the rim. $100/pr
3. 304 stainless race muffers. 4 1/2" inlet reduced to 4" muffler and turn down. Mufflers are Bassani race, very light weight. IIRC, they weigh less than 10 lbs for the pair. Fully ceramic coated. $450 invested will sell for $150/pr
4. Mallory fuel system. Comp 250 pump, Comp 500 filter and a new 4300 series 5 port return regulator...all for $250. Regulator and fittings alone were $200+.
5. Hotchkis trailing arm braces for the g-body. $50/pr
6. Centerline Convo-Pro wheels. Started life as 15 x 8.5 with a 4 7/8" back space. I sent them to Vaughn Machine in California and had them widened to 9.5" with a 5 7/8" back space. They replaced the while rear rim half and it was a very professional job. Widening alone cost over $450. Chevy 4 3/4" bolt pattern. $250/pr
7. Moroso trick coils (front) for G-body, 250 #/in version $10/pr
8. Moog/TRW stock replacement rear coil springs for the G-body. $10/pr
9. Crane cam lock plate $1.00
10. roll of trailer brake wire. 12 gauge cable, 2 conductor in a protective jacket. Started out as a 250 foot roll, still should have 150 feet left on the roll. $25
11. Moroso solid motor mounts for sbc in a first gen Camaro or Nova of same vintage. Ceramic coated. $10.00 pr.
I also have a RPM Performance data logger and Daytona Sensors Wego II wide band systems that may be available for sale too.
Parts are located in Westminster, MD for pickup.
e-mail
geislert@qis.netTodd
